Atlantic Beach Artificial Reef

Atlantic Beach Artificial Reef

3.0 nautical miles south of Atlantic Beach, 0.64 sq miles
Depth: 55 - 64 ft

There is a continuous wall between points 11 and 12 that someone apparently didn't think was important enough to draw in. See the side-scan below.

Not Shown:

  • automobile & truck bodies, long gone
  • 10,000 tire units
side-scan sonar image of Atlantic Beach Reef, click to enlarge

80 ft steel barge
Type:
artificial reef, barges
Depth:
55 - 64 ft
Name Description Sunk GPS
80 ft steel 40°31.884'
-73°43.297'
85 ft steel 40°31.942'
-73°42.894'
100 ft steel 40°31.631'
-73°43.029'
140 ft steel 40°31.736'
-73°42.736'
150 ft steel 40°31.903'
-73°43.166'
150 ft wood 40°31.762'
-73°43.306'
75 ft steel Thursday
Nov 14, 2019
40°31.604'
-73°43.611'

rock reef
A hopper barge full of rock

All manner of concrete, steel, and stone rubble from dredging, demolition projects, and other construction is used as artificial reef materials. This material is generally available at very low cost or free from construction companies who are more than happy to get rid of it. Transportation costs determine where this material is used by the Reef Program.


Fran S reef
Type:
artificial reef, tugboat
Built:
1899
Specs:
( 84 ft )
Sunk:
early 1970s - Atlantic Beach Reef
Depth:
80 ft
GPS:
40°31.711' -73°43.438'

sank during dredging operations

later raised, moved, and re-sunk as part of reef

intact, upright


M60 tanks reef
M60 tanks undergo a thorough cleaning before use as reefs

The Artificial Reef Program used four types of obsolete Army armored vehicles as artificial reef materials off the New Jersey coast. These were cleaned at local military bases, loaded onto barges for transport, and pushed off at their final destination. Once the Army had disposed of its excess inventory, the program ceased, around 1999. The Artificial Reef Program has sunk almost 400 tanks altogether, far too many to list them here in this website.


Comments on Atlantic Beach Reef

Questions or Inquiries?

Just want to say Hello? Sign the .

Submit a Comment

Your email address will not be published. Required fields are marked *


Click image to replace if unable to read.

Enter the digits from the image above, except for the last one:

This site uses Akismet to reduce spam. Learn how your comment data is processed.


regulator

Hose protectors are those funny rubbery tubes that fit over the ends of your air hoses. Their purpose is to prevent the hose from being bent sharply at the connector, which will eventually cause it to fail. However, they are practically impossible to put on. Here's a hint that makes it easy:

Soak the hose protector for a few minutes in not-quite-boiling water. This will make it much more soft and pliable. Then fish it out and jam it onto the hose quickly before it cools and hardens. Be careful not to get water in the hose orifice. Maybe I'm slow, but it took me quite a while to figure out this simple trick.