City of Athens (1/2)

Shipwreck City of Athens
Type:
shipwreck, liner, USA
Built:
1911, New York Shipbuilding, Camden NJ USA, as Somerset
Specs:
( 309 x 46 ft ) 3648 gross tons, 135 passengers & crew
Sunk:
Wednesday May 1, 1918
collision with French Navy cruiser La Gloire - 67 casualties
Depth:
110 ft

Today the City of Athens sits in 110 ft of water on a sandy bottom. The wreck is in one contiguous piece, however, quite broken up. The most distinctive features are the large boilers near her midsection. Decking and hull plates have collapsed in on her. There is a small section of wreckage believed to be the bridge not far off the port side, some 30 yards or so. The mass of twisted wreckage gives good home to fish and lobsters. Artifacts are also found. Ammo, bottles, brass, and china, have all been found. While some can still be found amidst the metal, most artifacts require digging. Because of her distance from shore, visibility is usually quite good, averaging around 35-40 ft, and occasionally exceeding 60.

The bow is quite intact with the anchor resting at the same place it was stowed. The depth at this point is 93 ft and drops to around 108 as you descend into the hold.

Fish are everywhere, but few large specimens. A nice school of Spadefish cruised the wreck during our visit. Artifacts are present for the patient hand-fanner, along with lobsters. Bits of broken glass and pottery shards lie exposed from earlier artifact hunters. Mussels hang in pods from the rusting hulk.

Visibility is better when a current is present on this site. We had around 25 ft with nice ambient light. Conditions can be on the intense side at times - darkness and a swift current are not uncommon. This should be considered an advanced dive.

- Jeff Barris

Shipwreck City of Athens New York Times
 1 2  

Comments on City of Athens

Questions or Inquiries?

Just want to say Hello? Sign the .

Submit a Comment

Your email address will not be published. Required fields are marked *


Click image to replace if unable to read.

Enter the digits from the image above, except for the last one:

This site uses Akismet to reduce spam. Learn how your comment data is processed.


storage box

The standard means of moving and storing dive gear is the dive bag. All of the major manufacturers make dive gear bags. These are often quite fancy, with embroidered logos, pockets inside and out, "ergonomic" handles, and even wheels. Most of these bags are very nice but really too small to hold a cold-water dive kit, and very heavy to carry around when full. These bags are also expensive, a bother to clean, and a lot less waterproof than they claim. Here's is a convenient alternative that is much cheaper:

Go to K-Mart Home Depot and spend $5 on a Rubbermaid tote box, about the size of a milk crate. This will not be big enough to hold all items - you'll have to pack your fins and BC separately - but it will hold everything else, is small enough to fit almost anywhere, and also avoids making a single excessively heavy load. The tote also will not lose small items like a milk crate will. I eventually drilled drain holes in the bottom. I now use my fancy dive bag only to carry my drysuit and its accessories. This type of tote box is the preferred container on every area dive boat I have been on.