Hylton Castle

Shipwreck Hylton Castle
Type:
shipwreck, steamer, England
Built:
1871, England
Specs:
( 251 x 32 ft ) 1258 gross tons, 22 crew
Sunk:
Monday January 11, 1886
overloaded and foundered in storm - no casualties
Depth:
95 ft

The Hylton Castle is pretty well broken up. It appears her cargo of corn, increasing in size with the saturation of water, eventually burst open her iron hull. Her wreckage is flattened out, spread over a wide area, with some pieces rising 15 ft or so off the sandy bottom. Usually ignored in favor of the nearby San Diego.

Hylton Castle

CDROM

The British three-masted freight steamship Hylton Castle was built in Sunderland, England, in 1871 by the Oswald and Co. shipbuilders. She was 251 feet long, 32 feet wide, displaced 1,258 gross tons, had seven water-tight compartments, and was owned by Surtees and Co., of North Shields.

On January 11, 1886, while bound from New York to Rouen with a cargo of 57,880 bushels of corn, the Hylton Castle got caught in a heavy gale. After a terrific beating, she literally began to break up. The crew abandoned her into two lifeboats with one containing nine men and the other 13. Within an hour, the big ship sank, bow first into the freezing ocean. One lifeboat managed to row ashore through the icy winter weather. Captain Colvin and his boat didn't have it as good. They broke three oars and ended up drifting for three days before being picked up by the fishing smack Stephen Woolsey.

Today, the Hylton Castle lies twenty-two miles out from Jones Inlet in 95 to 100 feet of water. Her scattered wreckage is an excellent home for Sea Bass, Blackfish, cod, ling, and lobsters. Her steel propeller protrudes from her scattered low-lying stern section. Just forward of her propeller on her port side is the remains of a wooden helm wheel. This helm has a steel hub and stand and is in very poor condition. In fact, divers will have to look very closely just to recognize it. The wreck's engine comes to within 85 feet of the surface. In front of her engine are two boilers and a condenser. Forward of her engine area is low-lying steel hull plates. In her bow divers will find a winch and capstan. This wreck is often overlooked by serious wreck divers because it is so close to the popular San Diego wreck. The wreck should not be underestimated as she still holds not only an abundance of lobsters but quite a few artifacts.

Excerpted from Wreck Valley CDROM by Dan Berg

Shipwreck Hylton Castle New York Times
Shipwreck Hylton Castle New York Times
Hylton Castle
Hylton Castle in England


Comments on Hylton Castle

Questions or Inquiries?

Just want to say Hello? Sign the .

Submit a Comment

Your email address will not be published. Required fields are marked *


Click image to replace if unable to read.

Enter the digits from the image above, except for the last one:

This site uses Akismet to reduce spam. Learn how your comment data is processed.


storage box

The standard means of moving and storing dive gear is the dive bag. All of the major manufacturers make dive gear bags. These are often quite fancy, with embroidered logos, pockets inside and out, "ergonomic" handles, and even wheels. Most of these bags are very nice but really too small to hold a cold-water dive kit, and very heavy to carry around when full. These bags are also expensive, a bother to clean, and a lot less waterproof than they claim. Here's is a convenient alternative that is much cheaper:

Go to K-Mart Home Depot and spend $5 on a Rubbermaid tote box, about the size of a milk crate. This will not be big enough to hold all items - you'll have to pack your fins and BC separately - but it will hold everything else, is small enough to fit almost anywhere, and also avoids making a single excessively heavy load. The tote also will not lose small items like a milk crate will. I eventually drilled drain holes in the bottom. I now use my fancy dive bag only to carry my drysuit and its accessories. This type of tote box is the preferred container on every area dive boat I have been on.

Printed from njscuba.net